Tianjin Haigang Steel Coil

Service first, quality assured. More dedicated and focused on crafting even better boards.


17

2021

-

11

Comparison between Continuous Annealing Furnaces for Cold-Rolled Sheets and Continuous Annealing Furnaces for Hot-Dip Galvanizing


Serial number

composition

Continuous Annealing Furnace for Cold-Rolled Sheets

Serial number

composition

Hot-dip galvanized continuous annealing furnace

1

Preheating section

     Preheat with exhaust gas from the heating section. Strip steel, bringing the strip temperature to 180 Celsius Left and right

1

Preheating section

Use the exhaust gas from the heating section to preheat the steel strip, bringing its temperature up to... 250 Celsius

2

Heating section

The steel strip is heated using a radiant tube equipped with an air preheater. The furnace is filled with a protective gas and reaches a temperature of... 730 Celsius , approximately time 1min

2

Heating section

Heating is performed using radiant tubes equipped with an air preheater. The furnace is filled with a protective gas and reaches a temperature of... 730 ℃, approximately 1 minute

3

Equalizing section

The strip steel is held at the annealing temperature for approximately: 1min The heating system has the same structure as the furnace’s heating section.

3

Equalizing section

Steel strip insulation approximately 20s It uses resistive heating elements for heating, and requires low power during large-scale production.

4

Jet cooling,

High-hydrogen quenching with rapid cooling

Cooling by jetting protective gas to rapidly cool the strip steel. Cool to 560 Celsius , Cooling rate of high-strength steel 180 Celsius /s

4

Cooling section

The strip steel is cooled by adopting a protective gas-circulating jet cooling method. 460 ~ 520 Celsius

5

Reheating section

Use Natural gas radiant tube heating heats the strip steel to... 450 Celsius

5

None

 

Galvanized strip steel